Q: About software and cpu maintenance: Does the software runs on Windows? And if software fails? Does machine has it’s own backup?
2022-05-30
A: About the maintenance of software and hardware: it runs on Windows, and the hardware goes through strict repeated inspection and aging test before leaving the factory to ensure stable operation in the later stage; the software has one-key restore backup and archive backup, which can easily repair the faults caused by viruses and abnormal loss of files.
Q: Does your machine use ruby or diamond nozzle?
2022-05-27
A: Yes, we use BMG diamond nozzle.
Q: I’m interested to know more about transit wheels and tension system, usually tension at wire becomes a problem.
2022-05-27
A: The WEDM-MS is equipped with a mechanical tension mechanism as standard, and the WEDM-LS is equipped with an automatic tension sensing system, the material of the molybdenum wire is different from that of the brass wire, so their own tensile force are also different. After the molybdenum wire is installed, if the requirements are high Basically, the tension needs to be adjusted after 48 hours until the next replacement!
Q: In software pictures everything is in Chinese, can be changed to English?
2022-05-26
A: Yes, the system can be set to all English.
Q: It says the machine with automatic vertical alignment function. How does it work?
2022-05-26
A: When you press the vertical automatic calibration button, the machine tool will automatically tilt the molybdenum wire to the edge of the upper part of the workpiece first, and then to the edge of the lower part of the workpiece. Finally, the system will automatically make the molybdenum wire parallel to the required machining surface after calculation, which can realize the automatic verticality calibration function.
Please note: the upper and lower edges of the workpiece cannot be chamfered, and the surface of the workpiece must be flat. Otherwise, it is not recommended to use the vertical automatic calibration function, then you can manually calibrate the perpendicularity as usual.
Please note: the upper and lower edges of the workpiece cannot be chamfered, and the surface of the workpiece must be flat. Otherwise, it is not recommended to use the vertical automatic calibration function, then you can manually calibrate the perpendicularity as usual.